Mitsubishi Repairs & Diagnostics Manchester

Why is my Mitsubishi juddering or shuddering when pulling away?

This is one of the most common complaints we hear from Mitsubishi owners. The Colt, Lancer, ASX, Outlander, Shogun, Eclipse Cross and L200 are models we see regularly. The judder often happens because the clutch pack, torque converter, valve body, mechatronic unit or transmission fluid condition has started to deteriorate, and smooth pull-away goes with it. It is most noticeable in slow-moving traffic, on hills or when reversing. Some owners put up with it for months assuming it is normal. It is not. Left long enough, clutch wear, valve body issues, torque converter wear and mechatronic faults can cause further internal damage. A gearbox diagnostic will confirm the fault within an hour.

We rebuild and recondition Mitsubishi gearbox units in Manchester. Most jobs are completed in one to two days*.

What does the DSG or gearbox warning light mean on an Mitsubishi?

A gearbox warning light on an Mitsubishi typically means the mechatronic unit, clutch pack, valve body, torque converter or transmission sensor has detected a fault. The most common causes are valve body wear, mechatronic faults, low hydraulic pressure, worn clutch packs, solenoid faults, contaminated gearbox oil or a torque converter problem. In some cases the car will refuse to select gears and go into a safe or limp mode. Do not ignore a gearbox warning light. Continuing to drive with a fault can turn a repairable issue into a full rebuild or replacement.

We have specialist software to read Mitsubishi gearbox fault codes and the parts to repair CVT, SST, automatic and manual units properly. A diagnostic starts from £30.

How much does an Mitsubishi gearbox repair cost in Manchester?

It depends on the gearbox type and the fault. A CVT, SST, automatic and manual repair, valve body rebuild, clutch repair or torque converter replacement are all very different jobs in terms of parts and labour. Our prices are up to 60% less than a Mitsubishi main dealer for the same quality of work using approved parts. We quote a fixed price before we start. There are no hidden charges and the £30 diagnostic fee comes off your repair bill if you go ahead.

Call 01616740142 for a ballpark figure on your specific model and fault.

Can I drive my Mitsubishi with a gearbox fault?

Some faults allow short journeys but most get worse quickly under load. If your Mitsubishi has a gearbox warning light, is slipping between gears on the motorway, is refusing to select drive or reverse, or is making grinding or clunking noises, you should not drive it further than necessary. Continuing to drive with an active gearbox fault almost always turns a repairable problem into a full rebuild or replacement. We offer vehicle recovery across Manchester if your car cannot be driven to us.

Is it worth repairing an Mitsubishi gearbox or should I replace it?

Repair or reconditioning is almost always cheaper than replacement. A full gearbox replacement is expensive regardless of who does it. The majority of Mitsubishi gearbox faults are repairable. Mechatronic failure, clutch wear, torque converter faults, valve body faults and fluid leaks can often be fixed without replacing the whole unit. We diagnose first, quote second, and only start work when you approve it. We will only recommend a full replacement if the unit is beyond economic repair. You will not be sold unnecessary work.

Will repairing my Mitsubishi gearbox affect my manufacturer's warranty?

No. Under Block Exemption legislation you have the legal right to use any qualified independent specialist without voiding your Mitsubishi manufacturer's warranty. The only conditions are that approved parts are used and the technicians are qualified. We meet both requirements on every job. This applies whether your car is still under the original warranty or an extended warranty. You do not have to go to a Mitsubishi main dealer to keep your warranty intact, and you will almost certainly pay significantly less with us.

What are the most common Mitsubishi gearbox problems?

Mitsubishi gearboxes have a few common fault patterns. Mechatronic unit failure is responsible for many warning lights and gear selection problems. Clutch wear, valve body wear or torque converter faults can cause the characteristic shudder on pull-away. Solenoid and valve body faults can lead to jerky or delayed shifts. Oil contamination, low fluid level or poor fluid condition can damage multiple components at once. On automatic models, torque converter wear is a common cause of harsh shifting and shudder. Early diagnosis on all of these prevents much more expensive consequential damage.